INSTALLATION INSTRUCTIONS (continued)
32-F218 / SINGLE SIDED COMMUNICATING DEADBOLT
4
INSTALL STRIKE
Close door. Locate strike in
jamb and center line of strike.
Open door and extend line to
door stop. Measure half of door
thickness plus 1/8” from door
stop. Vertically mark centerline
for strike.
CENTER LINE
5
INSTALL THUMBTURN ASSEMBLY AND BLANK PLATE
Insert torque blade horizontally into deadbolt latch. Crank until indicator
assembly is flush with the door face. Mate the thumbturn assembly with the
torque blade on the indicator assembly. Insert the screws through the holes of
the thumbturn assembly and latch body. Tighten the screws to the threaded
posts of the blank mounting plate. Tighten the assembly so the complete
assembly is tight to the door.
JAMB
A.
Drill (2) 1” (25.4 mm) holes 1-1/4” (31.7 mm) deep
in door jamb, 5/16” (8 mm) above and 5/16” (8 mm)
below horizontal center line.
CAUTION:
Hole must be drilled a full 1-1/4” (31.7 mm) deep
to ensure proper functioning.
B.
Insert the strike and
tighten to the frame
with #8 screws.
C.
TORQUE BLADE
THUMB TURN
ASSEMBLY
BLANK
PLATE
