Taylor Freezemaster 336, Оригинальная инструкция по эксплуатации

Страница: 5 / 46

Section 1
1-1
Model 336, 338, 339
To the Installer
1
To the Installer
The following information has been included in the
manual as safety and regulatory guidelines. For complete
installation instructions, please see the Installation
Checklist.
Installer Safety
In all areas of the world, equipment should be
installed in accordance with existing local codes. Please
contact your local authorities if you have any questions.
Care should be taken to ensure that all basic safety
practices are followed during the installation and
servicing activities related to the installation and service
of Taylor equipment.
• Only authorized Taylor service personnel should
perform installation and repairs on the equip-
ment.
• Authorized service personnel should consult
OSHA Standard 29CFRI910.147 or the applica-
ble code of the local area for the industry stan-
dards on lockout/tagout procedures before
beginning any installation or repairs.
• Authorized service personnel must ensure that
the proper PPE is available and worn when
required during installation and service.
• Authorized service personnel must remove all
metal jewelry, rings, and watches before work-
ing on electrical equipment.
The main power supply(s) to the freezer must
be disconnected prior to performing any repairs. Failure
to follow this instruction may result in personal injury or
death from electrical shock or hazardous moving parts as
well as poor performance or damage to the equipment.
Note: All repairs must be performed by a Taylor service
technician.
This unit has many sharp edges that can
cause severe injuries.
Site Preparation
Review the area where the unit will be installed before
uncrating the unit. Make sure that all possible hazards to
the user and the equipment have been addressed.
Air-Cooled Units
Do not obstruct air intake and discharge openings.
Air-cooled units require a minimum of 3 in. (76 mm) of
clearance around
all sides of the freezer to allow for
adequate air flow across the condenser(s). Failure to
allow adequate clearance can reduce the refrigeration
capacity of the freezer and possibly cause permanent
damage to the compressor.
For Indoor Use Only: This unit is designed to operate
indoors, under normal ambient temperatures of

70

F to 75

F (21

C to 24

C). The freezer has
successfully performed in high ambient temperatures of
104

F (40

C) at reduced capacities.
This unit must NOT be installed in an area
where a water jet or hose can be used. NEVER use a
water jet or hose to rinse or clean the unit. Failure to
follow this instruction may result in electrocution.
This unit must be installed on a level surface to
avoid the hazard of tipping. Extreme care should be
taken in moving this equipment for any reason. Two or
more persons are required to safely move this unit.
Failure to comply may result in personal injury or
equipment damage.
Uncrate the unit and inspect it for damage. Report any
damage to your Taylor distributor.
!