Taylor DA8-A, Руководство по эксплуатации

Страница: 10 / 26

V - 21A
10
SET UP AND WELDING - STANDARD DA8 - A
Stage three is to set the required lift. The rear
end cap adjuster has a click detent which
allows the adjuster to stop every half
- turn. This
means that each half - turn ≈ 0.5mm lift.
Therefore, if 2mm of lift is required, turn the
rear end cap adjuster anti
- clockwise 4 clicks
from the zero position to set the lift.
IMPORTANT! If any changes are made to the
setting of the pistol, the chuck, ferrule grip, stud length etc. The lift may be affected and
this procedure may need to be re
- executed to ensure that the required lift is applied.
SET UP AND WELDING - A1 & A2 MODELS
Having selected and where necessary prepared
the chuck, it can now be fitted to the pistol. To
begin, remove the foot assembly by loosening
the thumbscrews on the front end cap (chuck
fitting may be accomplished without removing
the foot assembly. However, removal of the
assembly provides easier access).
Slide the chuck into bellows support and screw the chuck
into position on the M10 mounting thread on the front of
the pistol shaft.
Tighten the chuck into position using an appropriate
wrench (usually 14mm A/F for Euro chucks
- see page 25).
IMPORTANT! Do not over - tighten chucks. This
requires only hand tightening. Over - tightening may
result in un - warrantied damage to your pistol.