Taylor C302NP, Руководство оператора

Страница: 34 / 54

6-6
OPERATING PROCEDURES
Model C302 NPR
Operating Procedures
6
22. Slide the white, plastic front bearing onto the bearing
hub, making sure that the flanged end of the bearing
is resting against the freezer door. Do not lubricate
the door gasket or front bearing.
Figure 6-19
23. Position the freezer door onto the four studs on the
front of the freezing cylinder and push the door into
place. Install the four handscrews onto the studs and
tighten them equally in a crisscross pattern to ensure
that the door is snug. Do not over-tighten the
handscrews.
Note: If the freezer door does not fit into place easily,
position the open end of the beater assembly in the 11
o'clock position.
Figure 6-20
24. Position the baffle arm by inserting it down into the
hole on the baffle assembly which protrudes from the
door. Verify proper installation by moving the baffle
arm back and forth to be sure it moves freely.
Figure 6-21
Repeat steps 1 through 24 for the remaining

freezing cylinder(s).
Sanitizing
Important! If a unit is sanitized and will not be used for
an extended period of time, clean water should be used
to flush all sanitizer from the lines. Remove the water
from all the lines and components prior to storage of the
unit. Upon return to service, the unit must be sanitized
prior to use.
Note: The following instructions are for one side of the
unit. Each side consists of two freezing cylinders,
identified on the corresponding LCD as left (L) and right
(R).
101602
101597
101637