17
History record mode
In normal display mode, press
[SET/HISTORY]
to enter the history
record mode. In this mode, users can check the history data records
in past 20 hours, press
[+]
to view next history data record, press
[-]
to
view previous history data record. In normal display mode, press
[MODE]
key and
[SET/HISTORY]
key together for 3 seconds to enter
the factory regulation mode. In factory regulation mode, the
accuracy of indoor/outdoor temperature, indoor/outdoor humidity
and atmospheric pressure sensors can be adjusted.
Troubleshooting
FCC Info
If the Receiver does not receive a transmission from a remote unit
channel for 10 minutes, the wind speed, outdoor temperature and
humidity will show dashes. To correct this problem:
1.
Go to the remote location of that channel to check that the unit is
properly positioned, within the appropriate transmission range.
2.
If new batteries are faulty on the initial installation, install fresh
batteries. If you did not notice the Low Battery icon warning and
the product performed correctly after initial set up, the batteries
have lost their charge. Replace the batteries.
3.
Check to make sure the transmission path is clear of obstacles and
interference.
Caution:
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
Note:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. This equipment has
been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Code:
RMW-2752N
