Taylor-Dunn SS-025-34, Руководство по обслуживанию и запасным частям

Страница: 87 / 134

Suspension
Page 87
MS-534-13
SS and MX Models, DC System
RAISING THE REAR OF THE
VEHICLE
1: Block the front wheel.
2: Place a jack at each corner of the rear frame or
use an overhead hoist with dual chains or straps
connected at the corners of the rear frame.
3: Raise the vehicle to the height required by the
procedure being performed.
4: Use jack stands if any part of your body must be
under the vehicle at any time or, if the vehicle
must remain suspended while unattended.
NEVER lift both rear wheels off of the ground using
a single lift point.
The vehicle shall ALWAYS be supported at three
points. When raising the rear wheels off of the
ground, the 3-points would be the front wheel and
2-points at the rear on the left and right side furthest
apart.
Failure to support the frame at three points may
result in tipping of the vehicle causing severe bodily
injury and/or property damage
WARNING
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.
WARNING
FRONT FORK SPRINGS
The front fork springs are an integral part of the front
fork assembly.
If the springs require replacement then the fork
assembly should be replaced.