Taylor-Dunn ET 3000, Руководство пользователя

Страница: 66 / 216

Steering
Page 14
MB-T48-02
T-48 AC / ET 3000
REPLACE THE BALL JOINTS, TIE RODS, AND DRAG LINK
This section will refer to two different types of ball joints. One
type is has a grease fitting and a tapered shaft where it is
installed on the steering arm or pitman arm. The second cannot
be greased and has a straight shaft. See the illustrations to
the right. Depending on the configuration of your vehicle, it
may be equipped one or both types of ball joints.
In this text:
The first type will be referred to as a “Ball Joint.”
The second type will be referred to as a “Rod End.”
Note: If a rod end or ball joint is worn out, we
recommend replacing all of the ball joints
and/or rod ends as a set.
Replacing a Rod End
6. Raise the front of the vehicle and support with jack stands.
7. Loosen the rod end jam nut or clamp on the steering sleeve.
8. Remove the rod end nut.
9. Remove the rod end from the steering arm.
Hint: Count the number of turns required to
remove the rod end from the steering
sleeve. This will make it easier to
realign the wheels.
1. Make sure the key-switch is in the “OFF” position, then remove
the key.
2. Place the forward-reverse switch in the center “OFF” position.
3. If equipped with a hand operated park brake, set the brake.
4. Place blocks under the rear wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in severe bodily injury.