Taylor-Dunn BIGFOOT B5-440-36, Руководство по эксплуатации, устранению неисправностей и замене запасных частей

Страница: 61 / 130

Motor
Page 61
MB-440-01
B5-440-36 / B5-440-48
7: Remove the armature (1).
a: Remove the motor encoder (9) by removing the bolts
(23).
b: Gently tap the armature using a soft faced hammer
and 1” hollow pipe around the armature magnet (see
illustration).
c: Reinstall the motor encoder (9) by installing the bolts
(23).
8: Using a soft face hammer tap on the rear motor
housing (4) to separate it from the stator (2).
DISASSEMBLE
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.
WARNING
Refer to illustration of exploded motor (found later
in this section)
1: Mark where the front end housing (3), rear motor
housing (4), and the stator (2) are aligned in
relation to each other.
2: Remove the three screws (24) from the sensor
cover plate (7).
3: Remove the four bolts (22) from the speed sensor
(9).
4: Remove the wire clamps (18/19) and terminal
block hardware (26).
5: Remove the six drive end bolts (21) from the front
motor housing (3).
Use CAUTION when removing rear motor housing to
prevent wire damage
NOTICE
6: Using a soft face hammer, gently tap on the front
motor housing (3) to remove.
Note: Do not lose the wave washer (15).
For specific torque values please refer to Hardware
Torque table found at the end of this chapter.
NOTICE