Taylor-Dunn BG-015-00, Руководство по эксплуатации, устранению неисправностей и замене запасных частей

Страница: 61 / 174

Maintenance, Service, and Repair
Steering Page 15
REPLACE THE BALL JOINTS, TIE RODS, AND DRAG LINK
This section will refer to two different types of ball joints. One
type is has a grease fitting and a tapered shaft where it is
installed on the steering arm or pitman arm. The second
cannot be greased and has a straight shaft. See the
illustrations to the right. Depending on the configuration of
your vehicle, it may be equipped one or both types of ball
joints.
In this text:
The first type will be referred to as a “Ball Joint.”
The second type will be referred to as a “Rod End.”
NOTE: If a rod end or ball joint is worn out, we
recommend replacing all of the ball joints
and/or rod ends as a set.
Replacing a Rod End
6. Raise the front of the vehicle and support with jack stands.
7. Loosen the rod end jam nut or clamp on the steering
sleeve.
8. Remove the rod end nut.
9. Remove the rod end from the steering arm.
HINT: Count the number of turns required to
remove the rod end from the steering
sleeve. This will make it easier to
realign the wheels.
Rod End
Ball Joint
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in severe bodily injury.
Rod End Nut
Rod End
Jam Nut
Steering
Sleeve
Steering Arm
1. Make sure the key-switch is in the “OFF” position, then remove the
key.
2. Place the Shift lever in the neutral position.
3. Set the park brake.
4. Place blocks under the rear wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the battery.