Taylor-Dunn B0-050-00, Руководство по эксплуатации, устранению неисправностей и замене запасных частей, Страница: 27 / 233

Safety Rules Page 13
SAFETY RULES AND OPERATING INSTRUCTIONS
Explosive mixtures of Hydrogen gas are
present within battery cells at all times. Do
not work with or charge battery in an area
where open flames (including gas furnace
or water heater pilots), sparks, cigarettes,
or any other sources of combustion are
present. Always provide ample ventilation
in rooms where batteries are being charged.
Failure to do so may result in severe bodily
injury and/or property damage.
CHARGING YOUR VEHICLE
Battery electrolyte is poisonous and
dangerous. It contains sulfuric acid. Avoid
contact with skin eyes or clothing. Wear
rubber gloves and safety glasses while
servicing batteries. DO NOT INGEST! This
may result in severe bodily injury.
Signet Charger Operation, Model HB Series
The Signet ® HB series
chargers use a semi-
automatic charging
system. The charger will
turn itself ON when the
AC power cord is
connected to the AC
power source and turn
itself OFF when the batteries are fully charged. Refer
to the data plate on the charger for the voltage and
type power required for the charger.
There is a series of LED’s on the faceplate of the
charger that serve two functions:
1. Status of charge. The LED’s will display an
approximate percent of charge during the
charging cycle. Refer to the table below.
2. Error condition. All
three LED’s flashing is
an indication of a
charging problem
(charger will also be
beeping). Refer to the
C h a r g e r
T r o u b l e s h o o t i n g
section for information on error codes.
Charging State
LED1 LED2 LED3
0 to 50% Blinking OFF OFF
50% to 75% ON Blinking OFF
75% to 100% ON ON Blinking
Cycle complete ON ON ON
Typical Signet
®
Built In
The key switch must be in the “OFF” position
when charging the batteries. Failure to turn
the key switch “OFF” may result in damage to
the vehicles electrical system.