Taylor-Dunn B 50, Руководство по эксплуатации, устранению неисправностей и замене запасных частей

Страница: 53 / 233

Maintenance, Service, and Repair
Steering Page 5
Rotate the steering wheel from a full left turn to a full right turn and
make sure that the ball joint clamps do not contact any other
component. Clamps positioned so that they contact other components
may result in steering failure and loss of control of the vehicle causing
severe bodily injury and/or property damage.
Tie Rod
Sleeve Clamps
Front Measurement
Rear Measurement
11. Measure the distance between the lines at the front
of the tires.
12. Measure the distance between the lines at the rear
of the tires.
13. Adjust the tie rod so that the distance at the front
and rear of the tires is the same.
14. If equipped with ball joints, position the ball joint
clamps in their original location and orientation.
15. Tighten the ball joint clamps (28-32 ft. lbs.) or the
rod end jam nuts.
16. Untie the steering wheel.
17. Reconnect the main positive and negative cables at the batteries.
18. Remove the blocks from behind the wheels.
19. Release the parking brake and test drive the vehicle.
NOTE: After completing this procedure, inspect the position of the pitman
arm while the wheels are in the straight ahead position. If the pitman
arm is not perpendicular to the ground then refer to
Center the
Steering
section to center the steering.
T
A Y
L OR - DU N
N
Th
e
B
e
st
W
ay
To
Go About
Yo
ur
Bu
si
n
e
s
s
R