HOW TO USE
RELEASE
LOAD
RELEASE
LOAD
RELEASE
LOAD
1.PLACE THE PAN SUPPORT ON THE STOVE
(see diagram)
2.HOW TO INSTALL CARTRIDGE
①
Open the cartridge cover.
·
Only use 220g butane cartridge BDP-220B
which complies with EN 417.
②
Make sure ignition knob is in "OFF" position
and cartridge lever is in "RELEASE"
position.
·
If the ignition knob is not completely in
"OFF" position, the cartridge cannot be
engaged into "LOAD" position.
③
Place the cartridge into the compartment.
Align the cartridge properly by inserting the
cartridge guide tab of the unit into the
cartridge slot on the rim of the canister.
④
Lock in place by pushing the cartridge lever
down to "LOAD" position and then close the
cartridge cover.
⑤
Check that the cartridge is positioned
properly, and the cartridge lever is in the
"LOAD" position.
⑥
You can now turn on the unit.
CAUTION
:
Incorrect
positioning
of
the
gas
cartridge
will
cause
the
burner
to
break
and
/
or
leak
which
will
produc
e
"
hissing
"
s
ound
,
and
a
smell
of
gas
.
3.HOW TO IGNITE
Turn the ignition knob counter-clockwise until
you hear a 'click' sound.
·
If the burner does not light, repeat the
ignition procedure.
·
Phenomenon
of
flaring
may
occur
during
warm
up
period
or
if
the
appliance
is
moved
.
The
flaring
will
stop
within
one
minute
or
when moving stops
.
4.HOW TO CONTROL FLAME
The size of the flame can be regulated by
turning the ignition knob slowly toward "OFF" .
5.HOW TO EXTINGUISH
Turn the ignition knob clockwise to "OFF"
position. The flame is automatically cut off and
no gas will be supplied.
·
The flame will be extinguished before the
ignition knob is turned completely to "OFF"
position.
·
Check to ensure the flame is extinguished.
6.HOW TO REMOVE BUTANE CARTRIDGE
Raise the cartridge lever up to the "RELEASE"
position. Open the cartridge cover and then
take the cartridge out. Ensure the ignition knob
is at "OFF" position.
7.HOW TO BURN OFF REMAINING FUEL
Some fuel may remain in the gas cock after
the unit has been turned off. For your safety,
with the cartridge lever in "RELEASE" position,
turn ignition knob to "ON" position to burn off
any remaining fuel.
!
CAUTIONS
MAKE SURE THE
CARTRIDGE SLOT
IS POINTING UPWARD
Cartridge Slot
Cartridge Guide
- 5 -
- 4 -
CAUTIONS FOR USE
- PLEASE READ CAREFULLY PRIOR TO USE
●
PROCEDURE FOR GAS LEAKAGE
Turn
the
cooker
knob
to
"
O
"
position
immediately
if
you
smell
a
strong
gas
odor
and
/
or
hear
a
"
hissing
"
sound
.
This
indicates
that
there
may
be
a
gas
leak
from
the
gas
cartridge
or
appliance
.
If
this
is
evident
:
1
.
Turn
the
ignition
knob
to
the
"
O
"
position
and
unlock
the
gas
cartridge
by
releasing
the
cartridge
loading
lever
to
the
”RELEASE”
position
.
2.Open all windows or move the appliance to a well-ventilated location away from any ignition source.
Do not use or turn on/off any electrical or gas appliance including telephones. Do not light flames or
use any equipment that could cause sparks or flames.
3.If there is a gas leak on the appliance and you cannot stop the gas flow or remove the gas cartridge,
relocate the appliance to a well-ventilated location away from any ignition source. Only check for
leaks outdoors using soapy water. Do not try to detect leaks using a flame. Do not inhale the gas at
any time.
4.Do not attempt to ignite the cooker any further.
5.Contact your dealer or service center.
●
AUTO SAFETY DEVICE
In the case of long term or excessive heat near the fuel cartridge, pressure will build up to set off the
safety device. The gas cartridge is automatically ejected in the event of over-pressure in the gas cartridge
and the flame will be extinguished. The unit will not operate until the gas pressure of the cartridge returns
to the normal range.
●
HOW TO RESET THE AUTO SAFETY DEVICE
1
.
Turn
the
control
knob
to
the
"
O
"
position.
2.Remove the gas cartridge.
3
.
Turn
the
ignition
knob
to
the
"
ON
"
position
and
wait
for
5
seconds
to
release
any
excess
gas
inside
the
unit
.
4
.
Return
the
ignition
knob
back
to
the
"
O
"
position
.
5
.
Push
the
cartridge
lever
down
to
the
"
LOAD
"
position
and
then
release
it
back
to
the
"
RELEASE
"
position
.
6.Determine the cause of over-pressure, i.e. Stove used in strong direct sunlight, an oversized pot/pan
has been used, insufficient ventilation, etc.
7.Make necessary adjustments to location, pot/pan used, and if necessary, allow the gas cartridge to
cool before re-installing. Another option is to install a fresh cool gas cartridge.
8.Follow the procedures for installing the gas cartridge and ignition, then re-ignite.
●
CLEANING & MAINTENANCE
1.The unit must be cleaned after each use and maintained at least once every six months. The unit
must only be serviced by a licensed plumber or gas fitter. For repairs, spare parts or service of the
appliance, please contact us or any licensed plumber or gas fitter.
2.When you notice small flame or no flame when you use a new cartridge, it may be that the injector is
too dirty or even blocked. You can clean the injector with a needle thinner than 0.47mm or you can
call the service center for advice.
●
COOKER BODY
1.After using the unit, it may be hot. Please wait for at least 10 minutes before you move or store it.
2.Ensure the unit is clean at all times. Only clean the unit after the gas cartridge is removed and the unit
has cooled. Clean the cooker body using a damp cloth. Use kitchen detergent if necessary. Wipe dry.
●
PAN SUPPORT AND DRIP PAN
Remove the pan support and drip pan and clean with warm water and kitchen detergent if necessary.
●
BURNER HEAD AND SURROUNDINGS
Soil, dirt, oil, dust, grime etc. can clog the burner and affect the flame. Clean the burner head with a
metal brush and keep water out.
●
IGNITION PLUG
Keep clean and dry. Clean with a dry cloth.
●
STORING THE STOVE
1. Turn Control Knob clockwise to "O" OFF position and return lever to the up position.
2. Allow stove to cool for 10-15 minutes.
3. Take unit outdoors away from any ignition sources. Remove butane cartridge.
4. Store butane canister consistent with instructions and warnings on the cartridge.
5. Use a soft cloth and clean greasy parts of the stove with soap and water or a nonabrasive detergent.
6. Check Lever on stove to be sure it in in the "UNLOCK" position.
7. Store stove in a cool, dry and well-ventilated area, out of the reach of children.
