TAVRIDA ELECTRIC ISM15_LD_1 Series, Инструкция по применению

Страница: 13 / 70

13
2
Trans port
ISM and CM shall be transported in the original packing only. The packed goods shall be handled in accordance with
the handling symbols. Loading procedures for ISM packing units shall be carried out only with fork lifts or cranes. If
possible the ISM packing unit shall be placed on a pallet. Lifting gear must not be attached to the support insulators.
During transportation the ISM and CM must not be hit or dropped.
Handling and Incoming Inspection
Before unpacking, please check the carton for damage and dampness. Removal of the products from the original
packing must be carried out with due care. Every ISM and every CM shall be subject to an incoming inspection.
Circuit breaker modules are heavy. Always use two people to lift out of the original packaging, with due care
and attention to safe lifting procedures.
Scope of delivery for the ISM:
ISM Screwdriver Operating manual Routine test certificate
Figure 11
When requested for 1000A operation, the ISM15_LD_1 and LD_3* require a heat sink set.
6x
12x
Heat sink
ITEA 741394.006
Bolts
ITEA 301611.004-03
2x
4x
Heat sink
ITEA 741394.006
Bolts
ITEA 301611.004-03
The ISM25_LD_1 and LD_3* require an insulating cap set.
3x 3x
Lower cover part
ITEA 711671.004
Sealing ring
ITEA 754152.002
3x
3x
Cap for upper
connecting bolt
ITEA 711121.002
Upper cover part
ITEA 714323.001
1x
1x
Lower cover part
ITEA 711671.004
Sealing ring
ITEA 754152.002
1x
1x
Cap for upper
connecting bolt
ITEA 711121.002
Upper cover part
ITEA 714323.001
Figure 12
Figure 13
*included
*included