TRADITIONAL HIGH LEVEL WC
Installation & care instructions
Please retain for future reference
2050mm MAX
Assemble the side entry
inlet valve as shown.
Screw the float into the swivel arm screw
and assemble inside the cistern tank as
shown. Check for free movement of the
float (ensure the float does not get caught
on the side/back wall of the cistern). To
adjust the water level rotate the water level
adjustment screw. Turn clockwise to
reduce shut-off level, turn anti-clockwise to
raise shut-off level, secure by hand
tightening the locking nut.
The inlet valve is fitted with a high pressure
seat (white), if water pressure is low, the
inlet valve is supplied with a low pressure
seat (red, attached to the inlet valve arm)
that can be swapped.
1. The underside of the cistern can be a maximum of 2080mm off the floor.
Fix the cistern brackets to the wall first. Put the cistern on top of the brackets and
mark the positions of the holes on the wall. Screw the cistern to the wall using the
fixing screws and washers supplied through the fixing holes in the back of the
cistern. Ensure the tank is firmly secured to the wall.
The high level pipe kit can be cut down if required.
Note: Any screws and plugs supplied are suitable for stone/brick walls only. If in
doubt consult and expert.
FILL VALVE - ASSEMBLY IN CISTERN
ASSEMBLY INSTRUCTIONS
IMPORTANT
Flush out all impurities in the cistern prior to installation.
FLUSH VALVE SPECIFICATIONS
Full Flush: 6L
Ensure the flush valve is assembled and fully tightened as shown, making sure the
rubber seal is over the thread of the valve and between the valve and the cistern.
Make sure that the fill valve and flush valve are not touching when assembled
inside the tank.
Use PTFE tape around the thread to ensure a water tight seal as shown below.
FLUSH VALVE - ASSEMBLY IN CISTERN
Once the outlet valve is assembled in the cistern, keeping hold of the
piston, remove the tie wrap. Once this has been removed, install the C-link
to the piston. To make the installation easier, the piston may need to be
pushed upwards from the underside.
Tie Wrap
C-Link
1.
2.
Back Nut
Rubber Washer
Back Nut
Locking Nut
Adjustment Screw
Arm
Float Connection
Assemble the flush arm to the tank. Attach the flush arm to the C-link on the flush
valve as shown. The handle and chain can then be attached to the flush arm.
Base
Seal
Siphon
FLUSH LEVER INSTALLATION
Back Nut
Round Head
Bolt
Plastic Washer
Flush Arm
Bracket
Brass Washer
Metal Nut
Flush Arm
Chain
1.
2.
REF: PL: 06 14 v1.0
