Taurus Single Pulley Design Line TF-PULL-SINGLE, Руководство по сборке и эксплуатации

Страница: 30 / 52

30
Single Pulley
Step 13
1. Remove the guide rod retainer (8).
L
NOTICE
Check the number of weight plates of the weight block (12). If you have a total of 14 weight
plates, use the spacers (15) when assembling the weight block. If you have 19 weight plates,
skip this step.
2. Slide the rubber donuts (16) onto the guide rods (4).
3. Slide all the weight plates of the weight block (12) one by one onto the guide rods (4).
4. Attach the top plate (10) to the selector rod (11) with the pin (29).
5. Screw the double pulley block (9) into the top plate (10).
6. Insert the selector rod (11) into the weight block (12).
7. Insert the guide rods (4) into the guide rod retainer (8).
8. Fasten the guide rods (4) to the guide rod retainer (8) using two screws (40).
9. Attach the guide rod retainer (8) to the main frame (1) with two screws (35).
L
NOTICE
The length of the cable can be varied by removing the screw on the top plate (10) and turning
the selector rod (11). Please refer to chapter 2.4.