8
attempt the installation yourself,but instead use a professional structural rigger,improper
installation can result in bodily injury and or damage to property.
The device has to be installed out of the reach of people.
If the device shall be lowered from the ceiling or high joists,professional trussing systems
have to be used,the device must never be fixed swinging freely in the room.
Caution:Device in hanging installations may cause severe injuries when crashing down!if
you have doubts concerning the safety of a possible installation,do NOT install the device!
Before rigging make sure that the installation area can hold a minimum point load of 10
times the devices weight.
DMX 512 control
Only use a DMX cable and 3-pin XLR plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
Occupation of the XLR connection:
DMX-output
DMX-input
XLR mounting-socket
XLR mounting-plug
If you are using controllers with this occupation,you can connect the DMX output of the
controller directly with the DMX input of the first device in the DMX chain.If you wish to connect
DMX controllers with other XLR outputs,you need to use adapter cables.
Building a serial DMX chain:
Connect the DMX output of the first device in the DMX chain with the DMX input of the next
device,always connect one output with the input of the next device until all devices are
connected.
Caution:At the last fixture,the DMX cable has to be terminated,Plug the terminator with a 120
Resistor between Signal(-) and ) in the DMX output of the last fixture.
Connection with the mains
Connect the device to the mains with the power-Plug.
The occupation of the connection-cables is as follows:
Cable
Pin
International
Brown
Live
L
Yellow
Earth
