After Sales Support
EMAIL: [email protected]
TEL: 1300 922 271
34. Allow the motor to reach top speed before you begin to
cut.
35. After you have switched on, lower the cut-off wheel slowly
until it comes into contact with the workpiece. Then carry
out a smooth cut. Avoid causing the cut-off wheel to jump
or chatter.
36. This will only lead to premature wear and result in poor
cuts or a broken cut-off wheel.
37. Workpieces are best cut when their angle in relation to the
cut-off wheel is kept as small a possible.
38. The number of cuts per cut-off wheel and their quality may
vary considerably with the time taken to make the cuts.
Fast cuts may accelerate wheel wear, but they also prevent
discoloring of the workpiece and the formation of burr.
This requires particular attention when cutting thinwalled
tubes. Do not reduce the cutting speed toward the end of
the cut, but cut right through to the end with full power.
This will help to prevent the material from overheating and
forming burr.
39. Always use the guard over cut-off wheel.
40. Never use the machine in the vicinity of combustible
liquids or gases.
41. To avoid electric shocks, never use the machine in damp or
wet locations, and never expose it to rain.
42. This electric tool was developed exclusively for cutting
ferrous metals. Do not try to cut wood, brick or magnesium
on this machine.
43. Do not stand in the cutting direction after a new cut-off
wheel has been fitted. Allow the machine to run for
approximately one minute before you begin with the
cutting. If the cutting- off wheel has an invisible fracture or
defect, it will burst in less than one minute.
44. Switch off the power supply before you carry out any
maintenance or adjustment work on the machine.
45. Should any part of your machine be missing, damaged
or out of order in any way, or should any electrical
components fail to work correctly, switch off the machine
and pull the power plug out of the socket-outlet. Replace
the missing, damaged or defective part before you carry
on with your work.
46. In the case of cut-off wheels with straightsided flanges, be
sure to observe the recommend values for thickness and
hole diameter.
Wear ear-muffs.
The impact of noise can cause
damage to hearing.
Wear a breathing mask.
Dust which is injurious to health can be generated
when working on wood and other materials. Never
use the device to work on any materials containing
asbestos!
Wear safety goggles.
Sparks generated during working or splinters,
chips and dust emitted by the device can cause
loss of sight.
Important!
When using equipment, a few safety precautions must be
observed to avoid injuries and damage.
Please read the complete operating manual with due care.
Keep this manual in a safe place, so that the information is
available at all times. If you give the equipment to any other
person, give them these operating instructions as well.
We accept no liability for damage or accidents which arise
due to non-observance of these instructions and the safety
information.
3. LAYOUT (FIG. 1/2)
1. Saw head
2. Handle
3. Adjustable guard for the cut-off wheel
4. Adjustable clamping face
5. Spindle
6. Hand crank
7. Stationary clamping face
8. Carry handle
9. Shaft lock
10. ON/OFF switch
11. Cut-off wheel
12. Table
13. Locking device
14. Overload switch
15. Vice
16. Lock screw
17. Lock screw
b. Safety lock
6