Taurus BOREAL 16CR DIGITAL, Быстрый старт

Страница: 4 / 7

ENGLISH
Stand fan
BOREAL 16CR DIGITAL
DESCRIPTION
A Front cover
B Front cover screws
C Front grille
D Blades fastening nut
E Blades
F Grille ring
G Grille fastening nut
H Rear grille
I Carry handle
J Motor shaft
K Motor housing
L Inner tube (**)
M Body fastening knob
N Inner tube fastening nut
O Outer tube
P Base cover
Q Round base
Base
R
screw
CONTROL PANEL
a) Speed selector
b) Timer
c)
OFF
d) Oscillation
REMOTE CONTROL
I) Speed selector
II) Timer
III) OFF
IV) Oscillation
(**) In case you do not see this piece, before
contacting our technical service make sure that
it is not located inside the piece (O), Take it out
carefully so as not to damage it.
If the model of your appliance does not have the
accessories described above, they can also be
bought separately from the Technical Assistance
Service.
USE AND CARE:
-Fully extend the appliance’s power cable before
each use.
-Do not use the appliance if the on/off switch
does not work.
-Do not move the appliance while in use.
-Do not use the appliance if it is tipped up and
do not turn it over.
-Disconnect the appliance from the mains when
not in use and before undertaking any cleaning
task.
-Store this appliance out of reach of children
and/or persons with physical, sensory or
reduced mental or lack of experience and
knowledge.
-Make sure that dust, dirt or other foreign ob-
jects do not block the fan grill on the appliance.
INSTALLATION
-Be sure to remove all packaging material from
inside the appliance.
-Ensure that the fan is switched off from the
supply mains before start any installation or
assembly operation.
-Ensure that the appliance is level with respect
to the
-The plug must be easily accessible so it can be
disconnected in an emergency.
ASSEMBLING THE BATTERY/S
-Remove the cover of the battery compartment.
-Check that the plastic covering that protects
the battery has been removed (some batteries
are sold with a protective covering)
-Put the battery in its compartment, respecting
the polarity.
-Close again the cover of the battery compart-
ment.
-It is essential that the batteries should always
be the same kind and the same charge. Never
mix alkaline batteries with normal one (Car-
bon-Zinc) and/or rechargeable ones.
ASSEMBLING THE BASE:
-Fix the base to the outer tube (O) using the
screw (R) provided (Fig.1).
-Check the base works properly.