Taurus ARTIS 60 INOX Ver III, Руководство пользователя

Страница: 12 / 36

Furniture fixing:
1. Drill 4 holes of 6 mm diameter in the bottom of
the furniture.
2. Place the one-way valve in the extractor hood,
then install the hood on the bottom of the
hanging unit, tighten the hood with the 4 screws
included.
3. Install the exhaust pipe.
NOTE:
If you don’t have an outlet to the outside,
the exhaust pipe is not necessary and the
installation is the same as before skipping the
part of the pipe (recirculation mode).
You will need two carbon filters to trap odours,
they are not included.
To install the carbon filters, remove the grease
filters as explained above, plug the filters into the
unit and turn them clockwise on both sides of the
motor, as shown below:
Make sure the filter is securely locked.
NOTE: When the carbon filter is connected, the
suction will be lower.
Modes
The device has 2 installation modes:
Recirculation mode and extraction mode.
Extraction mode:
The extraction mode expels the air to the
outside. This mode guarantees high
performance, high capacity and low noise level.
Recirculation mode:
The recirculation mode removes odours by
means of a carbon filter and reintroduces the air
into the kitchen. This mode is suitable for rooms
without extraction ducts, saves air and prevents
thermal losses to the outside.
For this mode, you need to obtain the carbon
filters and install them as explained in the
installation part, they are not included.
Instructions for use
Before use:
Remove the appliance’s protective film.
Make sure that all products’ packaging has been
removed.
Ensure that the selected tension on the voltage
selector coincides with the tension of the mains.
Use:
Connect the appliance to the mains.
Pull the telescopic tray.
Turn the appliance on, by using one of the speed
selection buttons (Fig.3).
Light function:
The appliance includes a light function, which
illuminates the working area under the appliance
(Fig.3).