Taurus ALPATEC AC351KT, Руководство пользователя, Страница: 21 / 200

Heat mode indicator will light.
-Press (c) to adjust the temperature
-Press speed (b) to increase or decrease
speed.
FAN MODE:
-Press mode to select fan mode fan indicator
turns on.
-Press speed to select high, mid or low speeds.
-Temperature is not adjustable.
DEHUMIDIFYING MODE:
- Press “MODE” to select dehumidifying mode,
dehumidifying mode indicator turns on.
- Remove the plug of drainage cap, insert a tube
and put the other side of the tube into water
containers or drain channels.
- When entering dehumidification mode, if the
room temperatures is ≥17ºC, the compressor
will start to work.
- If the room temperature is ≤15ºC, compressor
stops; when the temperature rises back to
≥17ºC, the compressor restarts (the compres -
sor shall meet the 3minute delay protection
function).
- In dehumidification mode, the fan run in low
speed by default, and the wind speed are not
adjustable. ·Temperature cannot be set.
- NOTE: When the dehumidification function
is in use, the exhaust pipe assembly shall be
removed; otherwise it will lead to not obvious
dehumidification effect or display “FL” water full
alarm.
COMPRESSOR PROTECTION:
- Three minutes later after power on / restart,
compressor starts to run.
WATER TANK FULL PROTECTION:
- When the water level in the bottom water plate
is above the warning level, the unit will alert
automatically a.
-Please discharge water in the machine accor-
ding to chapter “water drainage”.
WATER DRAINAGE:
- When the inner water tank is full, its indicator
will flash on the screen.
- The appliance enters into standby mode.
-
Pull out the plug to drain out water, power off
the machine and restart it , the machine will
runs normally .
-This model have self evaporative function,
under cooling mode, please do not use continue
drainage to get better cooling effect.
- Once you have finished using the appliance:
- Turn the appliance off, using the on/off switch.
- Unplug the appliance from the mains.
ONCE THE APPLIANCE HAS BEEN USED:
- Stop the appliance by pressing button (a) on/off
- Unplug the appliance from the mains.
- Unplug the appliance from the mains and allow
it to cool down before starting any cleaning
operation.
- Clean the electrical assembly and the mains
plug with a damp cloth and dry them after-
wards. NEVER SUBMIT THEM IN WATER OR
ANY OTHER LIQUID.
CLEANING
- Wipe the appliance with a damp cloth impreg-
nated with a few drops of detergent. Do not use
solvents or products with an acidic or basic pH
factor such as bleach or abrasive products to
clean the apparatus.
- Do not immerse the connector in water or other
liquid or place it under the tap. If the appliance
is not maintained in good condition
- Cleaning, its surface can be degraded and inex-
orably affect the life of the appliance and lead to
a dangerous situation.
CLEANING THE AIR FILTER:
- Clean the air filters every 2 weeks. If the air
filter is blocked with dust, its effectiveness will
be reduced.
- Washing the air filters by submerging them
- Carefully in warm water with a neutral deter-
gent, rinse them off and let them dry completely
in a shady place.
- Install the filters carefully after having them
cleaned.
AFTER PERIODIC MAINTENANCE:
- Switch off the appliance and remove the plug.
- Separate the exhaust pipe from the air and
store it carefully.
- Put the appliance in a dry place.
- Remove the batteries from the remote control
and store them carefully.
ANOMALIES AND REPAIR
- In the event of a fault, take the appliance to an
authorized service center. Do not attempt to dis-
assemble or repair it as there may be danger.
- Any person who is involved with working on or