Taurus AERO CRISP SPIN 6L, Инструкция по эксплуатации

Страница: 9 / 32

EN
English (Original instructions)
PREDEFINED MENUS
- This appliance has 10 preset programmes.
- To select a programme, press the menu
selector button (16) as many times as
necessary. The icon of the selected programme
will flash.
- If you want to change the temperature/time of
the selected menu, press the button (15) and
use the +/- buttons to adjust.
- Press the on/off button to start cooking. The
icon of the selected programme will remain lit.
- NOTE: Press the on/off button again if you
want to stop cooking.
- A beep will sound 3 times when cooking is
finished. The fan will switch off a few seconds
later.
- Remove the basket from the fryer.
- WARNING: The basket and the food will be
very hot.
- Remove the food from the basket.
TIME AND TEMPERATURE
- The cooking time can be set from 1 to 60
minutes.
- The cooking temperature can be set from 80ºC
to 200ºC.
- Press and hold one of the two +/- buttons to
decrease or increase the time quickly.
- The cooking time can be set in the preset
menu mode and also during cooking. The
selected time will be shown immediately on the
display.
INTERNAL LIGHT
- This air fryer has a light that allows you to see
inside while it is in operation.
- During cooking, the light turns on and off
automatically.
STIR FUNCTION
- When this function is activated, the stirring bar
rotates to automatically stir the food during
cooking.
- This function is available for the following 6
preset programmes: French fries, peanuts,
shrimps, nuggets, frozen potatoes, and pre-heat
function.
- In these programmes the "stirring" function is
automatically activated.
- The pre-heating function also has a stirring
function, but it must be selected manually.
- When the "remove" function is activated, a
fan-shaped light comes on in the display.
- To deactivate the function, press the
"remove" function button (13). The light will go
out.
- To reactivate this function, press the button
(13) again.
DELAY FUNCTION
- This function allows you to program the start
of cooking.
- The programming time can be from a
minimum of 30 minutes to a maximum of 540
minutes (9h).
- To programme cooking, you must first
choose the desired programme or the desired
temperature and time as explained above.
- Then press the "delay" function button (12).
Automatically the time and a clock pattern will
flash on the display.
Before the display stops flashing, choose the
time at which you want cooking to start.
- To do this, use the -/+ button.
- Each time one of the two -/+ buttons is
pressed, the appliance will beep and 30
minutes will be subtracted/added.
- Press and hold one of the two -/+ buttons to
quickly decrease or increase the time.
- Once the desired time has been entered,
wait until the display stops flashing.
- If the appliance has been properly configured
and the "delay" function has been activated,
the clock will be permanently lit on the display.
- To start the countdown, press the on/off
button.
- The countdown will be shown on the display.
Cooking will start when the timer reaches 0.
AUTOMATIC SHUT-OFF
- After 1 minute without touching the digital
control panel, the appliance switches off
automatically.
ONCE THE APPLIANCE USE IS
COMPLETED
- Unplug the appliance from the mains.
- Let it cool down.
- Clean the appliance as explained in the
"Cleaning" section.