2.3. Slide the seals onto the axle, put some
grease into the plain bearing bushing and onto
the seals and slowly slide the axle into the
pedal body.
Endcap
Washer
Ball
Bearings
Axle
Sealings
Plain
bearing
Nut
Manual Refresh Kit suitable for
LINK Composite, LINK, LINK TI, TWO-FACE Composite, CONTACT CNC
1.2. Unscrew the axle in the opposite direction
using the hexagon and Allen key included.
1.1. Unscrew the end cap with an Allen key. Hold the
pedal while doing so.
2. Press in bearings & assembly
1. Dismount Axle
1.3. Bearing and axle set in disassembled status
Refresh Kit consisting of:
- Ball bearing (4x)
- Plain bearing (2x)
- Weals (4x)
- Grease (1x)
- Hexagonal PIT (1x)
- Tool with washers (1x)
ATTENTION!
Left pedal => RIGHT THREAD!
Right pedal => LEFT SPEED!
Hexagon PIT
Allen key
2.1. Carefully tap out the ball bearing and then
clean the socket properly.
2.1. Slide the plain bearing over the tool with the
bevel first and press it in straight by hand with the
washer.
2.1.
2.2.
2.2.
Place the convex washer on the tool and push
in the ball bearing (A). Press in by hand and screw in
completely with end cap (B). Then remove the end
cap again.
A
B
The 1x1 of pedal sides
R
ight axle
without
notch &
silver nut.
L
eft axle
with notch &
Black nut.
2.5 Screw in the end cap with an Allen key and
approx. 10 Nm on aluminum pedals and 2.5 Nm on
composite pedals. Hold the pedal while doing so.
FINAL CHECK!
Axles must
rotate well and
be firmly
connected to
the pedal body.
DONE!
2.4. Insert nut and apply washer with a little
grease. Then tighten with hexagon and Allen key in
opposite direction with approx. 10 Nm.
Manual Version 230330
