TATUNG Wireless Thin Client (TX-2000) User Guide
11.1 Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This device complies with FCC RF Exposure limits set forth for an uncontrolled environment, under
47 CFR 2.1093 paragraph (d)(2). This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
TATUNG CO. declares that TWN-5213 ( FCC ID: BJMTWN5213-BZN ) is limited in CH1~CH11 for
2.4GHz by specified firmware controlled in U.S.A.
The Maximum average SAR (1g) for 802.11b is 1.040W/kg.
Содержание TWN-5213 CU
Страница 1: ...2005 6 27 page1 TATUNG Wireless Thin Client TWN 5213 CU ...
Страница 14: ...TATUNG Wireless Thin Client TX 2000 User Guide ...
Страница 19: ...TATUNG Wireless Thin Client TX 2000 User Guide ...
Страница 25: ...TATUNG Wireless Thin Client TX 2000 User Guide 3 Screens 1 through 7 of device calibration ...