User Manual (English version)_V2.0
11
2.6 Magnetic Control Switch
(1) Magnetic switch position
：
At the symbol of the
x-y-z coordinates
on the top side of
the sensor shell, put the magnet at the control position to activate
the sensor. If the sensor is not activated, move the magnet around
the symbol area to find the exact position.
NOTE
Neodymium magnet (NdFeB magnet) is recommended for better control.
(2) Control functions
：
function
Control method
LED light
Check the
sensor status
Put the magnet at the control position then the
LED light will be bright indicating the status.
Continuously
bright
：
green
,
yellow
,
red
Enable the
Bluetooth
signal
Put the magnet at the control position for
3
seconds, the LED
green light
will flash 3
times and then
enable
the Bluetooth function.
Continuously bright
green light
flash
Disable the
Bluetooth
signal
Put the magnet at the control position for
3
seconds, the LED
red light
will flash 3 times
and
disable
the Bluetooth function.
Continuously bright
red light
flash
Reset sensor
function
Put the magnet at the control position for
12
seconds (the LED
white light
will flash), then
remove the magnet to reset sensor function
(the LED light will flash
color light
).
Continuously bright
red/
green
light flash
light off
white light
flash
remove magnet
color light
flash
(3) Magnetic switch control process illustration show as below
：
Magnetic control
interval
No magnet
Less than
3 seconds
More than
3 seconds
Normal
Bluetooth enable
Bluetooth disable
Warning
Danger
LED light status
OFF / Flash
ON
Flash 3 times
