20
© COPYRIGHT 2006-2008 PRODEA SYSTEMS, INC. ALL RIGHTS RESERVED.
21
© COPYRIGHT 2006-2008 PRODEA SYSTEMS, INC. ALL RIGHTS RESERVED.
CONFIGURE TV Extender REMOTE WITHOUT A CODE
1
Turn on your
TV
or device. For this
procedure, we will use TV as an
example but this process works with
any supported device. Follow the same
steps, but use the
STB
or
AUX
button
instead of the
TV
button.
2
On the remote, press and hold the
TV
button and the
OK
button (Remote
Figure 3).
3
Release both buttons. All four
MODE
buttons (
ROS
sm
, AUX, TV
, and
STB
)
blink twice.
4
Enter the numbers 9-2-2 (Remote Figure
4).
5
Point the remote at the TV.
6
Press and hold the
PLAY
button. The
device button lights up every time a new
code is tried. The TV or device turns off
when you have found the right code.
The remote tries the most common
codes first. If the TV or device goes off
but you didn’t release the
Play
button
fast enough to catch the code, press
Rewind
to go back to the previous
code. When you have tried all the codes
stored in the remote, the entire remote
flashes twice and returns to normal
operation. You can exit the program at
any time by pressing
EXIT
.
You can program this remote to operate up to three additional devices such as a
DVD player, cable or satellite receiver, or television. This procedure describes how
to program the remote control by searching through all of the stored codes for your
device’s code.
Remote Figure 3: Press the
device and OK buttons
Remote Figure 4:
Enter 9-2-2
Remote Figure 5:
Press and hold Play
TV Extender REMOTE OVERRIDE INSTRUCTIONS
1
Using your
ROS
sm
remote control, press
and hold the
ROS
sm
and
OK
buttons.
2
Release both the
ROS
sm
and
OK
buttons. The buttons blink twice.
3
Enter the setup code for the function
reassignment (see below). The
ROS
sm
button blinks twice.
• Volume reassignment code:
9 – 5
– 5
. By default the volume control
passes through to your television,
so when you press the volume
button the volume is lowered at your
television. Use this assignment code
to configure another device to control
the volume.
• Channel reassignment code:
9 – 6 –
6
. By default the channel control is
passed through to the television. Use
this assignment code to configure
another device to control the
channels.
• Power reassignment code:
9 – 7 –
7
. You can set the
Power
button to
turn on and off one or more devices
simultaneously
.
4
Press the device button (
ROS
sm
,
TV
,
STB
and
AUX
) that you want to control
the function.
Complete the following process to change the default remote control settings for volume,
channel, and / or power functions so that these functions will always be controlled by
specific devices.
Remote Figure 3: Press the
device and OK buttons
Remote Figure 4:
Enter 9-2-2
Remote Figure 5:
Click Play
NOTE:
To reset your remote to factory
settings, press and hold the
ROS
sm
key.
While holding it down, press
OK
. Release
both keys. The device keys blink twice.
Press 9 - 0 - 0. The
ROS
sm
key blinks
three times to indicate that the reset was
successful.
