3-2 Check for Break Detection Function (Refer to Attached Drawing 3, Attached Drawing 4 and Drawing 3)
1) Check that the DIP switch for the circuit required to be checked has been set at “I”.
2)
After powering off the detector
, remove the water leakage sensor from the trunk terminal block and
then power on the detector.
3) The buzzer sounds, the break Indicator LED flashes, and individual contacts (break) function.
4) After the operation check,
power off the detector
, and then connect the sensor and the DIP switch again.
*When water leakage sensor circuit is not connected, set the DIP switch at “ON”.
*When water leakage sensor circuit is connected, set the DIP switch at “1”.
3-3 Check for Water Leakage Detection Function (Refer to Attached Drawing 3, Attached Drawing 4 and Drawing 3)
1) Check that the DIP switch for the circuit required to be checked has been set at “I”.
2) Drop tap water on the sensor.
3) The buzzer sounds, the water leakage Indicator LED flashes, and individual contacts (water leakage) function.
4) Wipe the tap water dropped on the sensor with dry rags, etc. and check that the water leakage status returns
to normal.
-4-
