TATA Motors Tiago NRG 2019, Руководство пользователя

Страница: 115 / 184

EMERGENCY AND BREAKDOWN ASSISTANCE
107
Rear jacking Location
Assemble the Jack handle and wheel
spanner (as shown in jacking fig.)
Raise it by turning the jack handle clock-
wise until the jack sits completely on
jacking point and the base of the jack
lies evenly on the ground.
Jacking
WARNING
If you do not position the jack cor-
rectly at the appropriate jacking
point of the vehicle, the jack could
tip over with the vehicle raised.
There is a risk of injury and jack
failure.
Continue to raise the jack slowly and
smoothly until the tyre clears the ground.
Do not raise the vehicle more than nec-
essary.
Remove wheel mounting nuts with the
help of wheel spanner and take out flat
tyre.
NOTE
Do not place wheel nuts in sand or
on a dirty surface. Do not apply oil
or grease on it.
Roll the spare wheel into position and
align the holes in the wheel studs.
Install wheel nuts with their cone shaped
end facing the wheel. Tighten each nut
by hand until the wheel is securely
seated on the hub.
Lower the jack completely then tightens
the wheel nuts one by one using wheel
spanner.
Press fit the wheel cover back (if
equipped).
Restore all the tools and jack at their
respective location.