TATA Motors SUMO GOLD, Руководство владельца и сервисная книжка

Страница: 86 / 110

86
Each headlamp is aligned individually by masking the other
headlamp. Headlamp is first adjusted for proper height of
low beam by adjusting knob at its top. Light from low beam
should fall below horizontal and inclined lines.
No light should fall above these lines i.e. in ‘Dark zone’.
Thereafter lateral adjustment is done by adjusting knob at
bottom of headlamp so that contour of low beam coincides
with contour formed by horizontal and inclined lines below
‘Dark zone’.
When properly adjusted, most brightly illuminated area will
be just below the intersection point ‘A’ of these two lines.
The Second head lamp is adjusted in a similar manner
without disturbing the position of the vehicle and the screen.
Now switch ‘ON’ high beam. They will be symmetrical above
points. ‘A’ and ‘B’ of intersection of vehicle lines and horizontal
lines. It is possible that high beams may not be exactly
symmetrical but for this reason headlamps should not be
realigned.
Preferably, the alignment should be done in the dark.
No masking of headlamps with black paint is required. If
done, this will reduce the intensity of light.
Head lamp focusing should be carried out in the level ’O’
position (where head lamp leveling switch provided ) of the
switch only.
Head lamp bulb replacement
Raise the bonnet of the vehicle. Remove the rear protective
cover. Pull out cable socket from bulb. Remove lock ring
holding the bulb and remove the bulb.
Install new bulb, properly locating it in the housing. Fit back
locking ring, cable socket and protective cover.
Realign headlamp beam after replacing bulb.
Do not clean the reflector as it will cause damage to mirror
- finished surface. Do not replace bulb with dirty or oily
hands, since oil will evaporate due to bulb heat and stain
the reflector.
VEHICLE MAINTENANCE ELECTRICAL SYSTEM