109
FUEL FIL
FUEL FIL
FUEL FIL
FUEL FIL
FUEL FILTER & FUEL SY
TER & FUEL SY
TER & FUEL SY
TER & FUEL SY
TER & FUEL SYSTEM
STEM
STEM
STEM
STEM
6. Refit the drain plug using a new sealing washer. Tighten
drain plug to 5 mkg. torque.
7. Fill, recommended quantity of fresh engine oil in the crank
case and secure the oil filler cap in its place.
8. Start the engine and run for a few minutes. The engine oil
pressure indicator lamp should go ‘off’ after starting the
engine.
9. Check for engine oil leakages.
10. Stop the engine and recheck engine oil level after a few
minutes. If necessary add oil to bring the level to the upper
mark on the dipstick.
NOTICE
NOTICE
NOTICE
NOTICE
NOTICE
Use of reclaimed oil is not recommended
Priming Pump
Priming Pump
Priming Pump
Priming Pump
Priming Pump
Priming pump is used for priming the fuel manually after
overhauling of the engine or after refitment of fuel lines. Pump
the fuel by means of priming pump until all air in the fuel line is
removed. Before cranking the engine ensure that there is no air
in the fuel system.
NOTICE
NOTICE
NOTICE
NOTICE
NOTICE
Please do not loosen/remove high pressure pipes and injectors
for air bleeding in the fuel.
M A I N T E N A N C E
FFFFFuel & F
uel & F
uel & F
uel & F
uel & Filt
ilt
ilt
ilt
ilter D
er D
er D
er D
er Drrrrraining
aining
aining
aining
aining
Loosen drain plugs by 1-2 turn and drain out water and other
sediments from fuel filter bowls depending on operating
conditions to ensure that no water is allowed to enter the fuel
system.
SSSSSedimen
edimen
edimen
edimen
edimenttttter
er
er
er
er W
W
W
W
Waaaaattttter D
er D
er D
er D
er Drrrrraining
aining
aining
aining
aining
Water sedimenter is located near fuel tank at rear left hand side
of the vehicle.
Loosen drain plug by 1-2 turns and drain out water and other
sediments from sedimenter when water level indicator lamp
glows in instrument cluster to ensure that no water is
allowed to enter the fuel system.
Sedimenter