TATA Motors nano emax, Руководство пользователя

Страница: 18 / 112

16
4. STARTING THE ENGINE
NOTICE
Your engine can start either in gas
mode or in petrol mode but it is
always advisable to start in petrol
mode & then switch to gas mode
.
•
To start, turn the ignition key to
“IGN” position. Ensure that all the
tell tales should glow for initial 3
seconds.
•
Select the desired fuel operating
mode by pressing the Fuel
Selector Switch.
•
Keep the clutch pedal fully
pressed and crank the engine. DO
not press the accelerator pedal.
•
If the engine cranks but fails to
start then repeat the above
procedure. Release the key as
soon as the engine starts. Ensure
that the “MIL” and ‘SIL’ lamps are
“OFF”. The CNG indicator lamp
will be ON, if the car is running on
CNG mode.
•
Starting time in CNG will be longer
than in petrol due to the physical
characteristics of the fuel.
•
Ensure that your car has sufficient
petrol in the tank as petrol is used
intermittently during operation for
keeping both the systems in
healthy condition.
•
Your car will run automatically in
petrol mode for almost 2 to 3 km
after every 60-70 Kms covered in
CNG mode to keep the petrol
system & CNG system in good
condition.
CAUTION
Do not crank the engine
continuosly for 10 seconds at a
time .If the engine doesn’t start on
the first try; wait about 15 seconds
before starting again.
5. FUEL MODES :
HOW TO SHIFT THE FUELLING
MODES
You can switch from PETROL to CNG
and vice versa by operating fuel
selector switch located on right hand
side of dashboard near steering
wheel. See below picture.
STARTING THE ENGINE & FUEL MODES
KNOW YOUR CAR
A. PETROL to CNG mode :
You can shift to CNG fuel mode by
pressing the fuel selector switch.
Based on the programmed delay
time the fuel mode changes to CNG
mode, CNG Indicator lamp turns ‘ON’
permanently indicating that the car
is running on CNG.
NOTICE
With ignition switch “ON” and
engine not running, blinking of
CNG Indicator Lamp in instrument