TATA Motors INDICA eV2 XETA CNG, Дополнительное руководство владельца

Страница: 6 / 24

4
c. Switch off ignition switch and manual shut off knob
located on cylinder valve before servicing / repairing
of any parts in the CNG circuit.
Also ensure CNG gas
pressure at pressure gauge is Zero. For doing so, we
can run vehicle in CNG mode after shutting off cylinder
valve. Do not run the vehicle until leakage is rectified.
d. Immediately contact nearest TATA authorized
service centre for further assistance.
NOTE: In case of gas leakage, ECU will automatically
switch the fuel mode from CNG to Petrol. The ECU will
not allow you to switch to CNG mode until the leakage
is rectified.
•
Get CNG Cylinder checked after every 5 years at Govt.
approved test Agency. Never fill CNG cylinder with air,
LPG or any fuel except CNG.
•
Keep the car away from any Fire source.
•
Remove the CNG tank during the welding/brazing work
on the Car.
•
Check/replace air filter as per service schedule
mentioned. Clean it during every service.
NOTE:
•
It is essential to have at least 10 liters of petrol AT
ALL TIMES to ensure trouble free operation in case
of empty CNG tank.
•
Run your car in petrol mode for at least 10kms after
every 300kms covered in CNG mode
to keep the
petrol system in good condition.
INTRODUCTION & SAFETY PRECAUTIONS
CNG cylinder OPEN / CLOSE knob in boot space
CNG Pressure Gauge in Engine Compartment