12
Parts sealed by the manufacturer or his agent must not be altered by the user. No modifications
should be made to any part of this oven and repairs and maintenance should only be carried out by
a GAS SAFE registered service engineer.
Rotisserie and motor
Warning
：
Rotisserie and motor must not be exposed to water or damp conditions or used when raining.
The plug of AC motor may be required to be plugged using an extension lead from indoor; this should not
be used in wet conditions because it may result in electrocution.
Connection to Appliance
Before connection, ensure that there is no debris caught in the head of the gas cylinder, regulator, burner
and burner ports. Spiders and insects can nest within and clog the burner/venturi tube at the orifice. A
clogged burner can lead to a fire beneath the appliance.
Clean burner holes with a heavy-duty pipe cleaner/wire brush.
Fit the hose to the appliance using a spanner to tighten it onto the connection thread. If the hose is
replaced it must be secured to the appliance and regulator connections with hose clips. Disconnect the
regulator from the cylinder (according to the directions supplied with the regulator) when the oven is not in
use.
The oven must be used in a well ventilated area. Do not obstruct the flow of combustion air to the burner
when the oven is in use. ONLY USE THIS OVEN OUTDOORS.
BEFORE USE CHECK FOR LEAKS
Never check for leaks with a naked flame, always use a soapy water solution
TO CHECK FOR LEAKS
Make 2-3 fluid ounces of leak detecting solution by mixing one part washing up liquid with 3 parts water.
Ensure the control valve is “OFF”.
Connect the regulator to the cylinder and ON/OFF valve to the burner, ensure the connections are secure
then turn ON the gas.
Brush the soapy solution onto the hose and all joints. If bubbles appear you have a leak, which must be
rectified before use.
Retest after fixing the fault
Turn OFF the gas at the cylinder after testing.
If leakage is detected and cannot be rectified, do not attempt to cure leakage but consult your gas dealer.
Lighting Instructions for barbecue
1.
Open the hood of the oven before attempting to light the burners
and remove the 3 stainless steel
trays
.
2.
Turn all the control knobs clockwise to “OFF” position.
3.
Connect the regulator to the gas bottle. Turn the gas supply “ON” at the regulator. Check with the use
of soapy water for any gas leakage between the bottle and the regulator.
4.
On one of the two burners, push in the control knob and turn it anti-
clockwise to the “HIGH” position,
at the same time hold in the ignition button (a clicking sound will be heard) this will light the pilot and
the burner. Keep pressing in the knob for a further 15 seconds observe if the burner has lit. If not,
repeat this process. Then repeat for the second burner if required.
