Match Guide
Use Match key
1. Match: Short press the match key on the receiver, within 5s, press on/off key of the remote
2. Delete: Long press the match key on the receiver for 5s, to delete on matched remote
Use Power-up
1. Match: Switch off the power, then switch on again, short press the on/off key 3 times on the
remote quickly within 5s after the power is on, the link is done once the light blinks 3 times
2. Delete: Switch off the power, then switch on power again, short press on/off key 5 times on
the remote quickly within 5s after the power is on, the unlink is done once the light blinks
5 times
External Push Switch (optional)
1. Short press: Turn on/off light
2. Long press(1-5s): When the light is on, increase or decrease brightness continuously
3. Long press(10s): When multiple controllers share a on/off key, this can achieve
simultaneous adjustment
Wiring Diagram
Malfunctions analysis & troubleshooting
1.
The product shall be installed and serviced by a qualified person.
2.
The product is non-waterproof. Please avoid the sun and rain.
3.
Good heat dissipation will prolong the working life of the controller. Please ensure good ventilation.
4.
Please check if the output voltage of any power supplies used comply with the working voltage of the
product.
5.
Ensure all wire connections and polarities are correct and secure
before applying power to avoid any
damages to the LED lights.
6. If a fault occurs please return the product to your supplier. Do not attempt to fix this product by yourself.
Safety information
Malfunctions
Causes
Troubleshooting
Uneven intensity
between front and
rear,with voltage drop
No response
from the remote
No light
Wiring diagram
Push Switch
(optional)
Power Supply
5-36VDC
Constant Voltage
AC110-230V
Single color LED strip
LED power supply voltage and power select:
●
5V lamp, Input 5V power supply, can load 0~40W,
●
12V lamp, Input 12V power supply, can load 0~96W,
●
24V lamp, Input 24V power supply, can load 0~192W,
●
36V lamp, Input 36V power supply, can load 0~288W,
The power supply power must larger than load power 20%.
+
1. Reduce cable or loop supply
2. Change wider wire
3. Replace higher power supply
4. Add power repeater
1. Replace battery
2. Reduce remote distance
3. Re-match the remote
1. The battery has no power
2. Beyond controllable distance
3. The controller did not match the remote
1. Output cable is too long
2. Wire diameter is too small
3. Overload beyond power supply capability
4. Overload beyond controller capability
1
.
No power
2
.
Wrong connection or insecure
1
.
Check the power
2
.
Check the connection
