IMPORTANT SAFETY INSTRUCTIONS - READ FIRST!
SAFETY WARNINGS
When using this product, basic precautions
should always be followed:
• Read all the instructions before using the
product.
• Water spray must never be directed towards any
electric wiring, devices or directly towards the
pressure washer machine itself or fatal electric
shock may occur.
• To reduce the risk of injury, do not operate the
machine near children.
• Learn how to stop the machine and release pres-
sure quickly. Be thoroughly familiar with the controls.
• Stay alert—watch what you are doing.
• For use with cold water supply only. Do not draw
other liquids.
• The pressure washer should not be used in areas
where gas vapours may be present. An electric
spark could cause an explosion or fire.
• To minimize the amount of water getting into the
pressure washer, the unit should be placed as far
as possible from the cleaning site during operation.
• Avoid accidental starts. Shut power “OFF” before
connecting or disconnecting cord to electrical outlets.
• Do not operate the product when fatigued or
under the influence of alcohol or drugs.
• Do not stand on unstable surfaces. Stand with
both feet balanced at all times.
• Prior to starting the pressure washer in cold
weather, be sure ice has not formed in any part of
the equipment.
• Never carry your pressure washer by the
cord. Do not pull on the cord to disconnect
from the outlet.
• To allow free air circulation, the pressure washer
should not be covered during operation.
• Keep operating area clear of all people.
• Follow the maintenance instructions specified in
the manual.
• This product is provided with a Ground Fault
Circuit Interrupter built into the power cord plug.
If replacement of the plug or cord is needed, use
only identical replacement parts.
• California Proposition 65: This product or its
power cord contains lead, a chemical known
to the State of California to cause cancer, birth
defects or other reproductive harm. Wash hands
after use.
WARNINGS
• Do not use with flammable liquids and toxic chemicals.
• Injection Hazard: Equipment can cause serious
injury if the spray penetrates the skin.
• Do not point the gun at anyone or any part of
the body. In case of penetration seek medical
aid immediately.
• This system is capable of producing 1750PSI.
To avoid rupture and injury, do not operate this
pump with components rated less than 1750PSI
working pressure (including but not limited to
spray guns, hose and hose connections).
• Before servicing, cleaning or removal of any
parts, shut “OFF” power and relieve pressure.
• Do not spray electrical apparatus and wiring. If
connection is made to a portable water system,
the system shall be protected against backflow.
WARNING
- Risk of Injection or Injury - Do Not
Direct Discharge Stream at Persons
• High pressure jet can be dangerous if misused.
The jet must not be directed at persons, animals,
electrical devices, or the unit itself.
WARNING
- Risk of Explosion - Do not spray flam-
mable liquids
• Do not use acids and solvents in this product.
These products can cause physical injuries to the
operator and irreversible damage to the machine.
CAUTION
- Gun Kicks Back - Hold with both hands
• The trigger gun safety lock prevents the trigger
from accidentally being engaged. The safety fea-
ture DOES NOT lock trigger in the ON position.
WARNING
- Risk of Electrocution
• Inspect cord before using - Do not use if cord is
damaged.
• Keep all connections dry and off the ground.
• Do not touch plug with wet hands.
• Do not use extension cord with the product.
SAVE THESE INSTRUCTIONS
Servicing of a double-insulation product:
In a double-insulation product, two systems of
insulation are provided instead of grounding.
No grounding means is provided on a double-
insulated product, nor should a means for
grounding be added to the product. Servicing
a double-insulated product requires extreme
care and knowledge of the system, and should
be done only by qualified service personnel.
Replacement parts of a double-insulated prod-
uct must be identical to the parts they replace.
A double-insulated product is marked with the
words “DOUBLE INSULATION” or “DOUBLE
INSULATED”. The symbol “ ” may also be
marked on the product.
1
Содержание ZE04
Страница 20: ...Printed in China ...
