©Copyright Task Force Tips LLC 2001-2022
3
LKF-050 February 21, 2022 Rev06
5.0 FRONT END DISASSEMBLY SEQUENCE
Disassembly for Fixed Teeth, Spinning Teeth, and QuadraCup differ. Choose the step for the model you are servicing.
5.1 SPINNING TEETH DISASSEMBLY
1. Using a 5/32” Hex Key, remove BUTTON HEAD SCREWS (40).
2. Slide BUMPER (39) and O.D. WEAR RING (38) off of the HEAD (44).
3. Remove SPINNING TEETH (41), I.D. WEAR RING (42), and “V” FOLLOWERS (6) from the HEAD.
4. The HEAD will now slide off the GALLONAGE SLEEVE (10).
5.2 FIXED TEETH DISASSEMBLY
1. Using a razor blade knife, cut through one side of the BUMPER (4) from top to bottom.
2. Remove the BUMPER from the HEAD (5).
3. Use a torch to heat the CUPS (7) to break the Loctite.
4. Remove the CUPS using a 7/32” Hex Key.
5. Remove the“V” FOLLOWERS (6) from the HEAD.
6. The HEAD will now slide off the GALLONAGE SLEEVE (10).
5.3 QUADRACUP DISASSEMBLY
1. Using an 1/8” Hex Key, remove the DETENT SCREWS (47).
2. The SPRINGS (13) and 3/16” TORLON BALLS (14) can now be removed from the CUP (46).
3. Slide the CUP off the HEAD and remove O-RING (48).
4. Use a torch to heat the CUPS to break the Loctite.
5. Remove the“V” FOLLOWERS (6) from the HEAD (50).
6. The HEAD will now slide off the GALLONAGE SLEEVE (10).
5.4 DEFLECTOR DISASSEMBLY
1. Cut the DEFLECTOR LABEL (1) off the DEFLECTOR (3) to expose spanner wrench holes.
2. Remove the HOLLOW LOCK SET SCREW (2).
3. Remove the DEFLECTOR using a spanner wrench.
5.5 GALLONAGE SLEEVE AND INDEX RING DISASSEMBLY
1. Using a torch, heat the CUPS (7) in the INDEX RING (17). Placing a wet rag over the NAME LABEL (12) will help to not damage
the label while heating the part.
2. Remove the CUPS using a 7/32” Hex Key.
3. Remove the“V” FOLLOWERS(6), SPRINGS (13) and TORLON BALLS (14) from the INDEX RING.
4. The GALLONAGE SLEEVE (10) can now be removed from the INDEX RING.
5. Using a torch, heat the SET SCREW (18) in the INDEX RING.
6. Remove the SET SCREW using a 5/64” Hex Key.
7. Remove the ACETAL BALLS (19) from the INDEX RING [16] by rotating the INDEX RING while holding the assembly with the set
screw hold down.
8. Slide INDEX RING off the BASE (21 or 45).
9. Remove the KEY PINS (11) from the GALLONAGE SLEEVE.
10.Remove the QUAD RING (9) and O-RING (20).
