Real People - Real Solutions Real People - Real Solutions Real People - Real Solutions Real People - Real Solutions
4
Trouble Shooting in Train Mode:
Due to the variety of different infrared transmission techniques, it may be necessary
to modify the training procedure for some devices. If a beep is not produced within one
or two seconds of pressing the original transmitter button, release the button and press it
again. This second button press should provide the RELAX 3 with the additional
information it needs to complete its training and result in a beep. In an unlikely situation
that training is still not successful; the RELAX 3 may not be receiving a strong enough
signal. Try repositioning the two units and repeating the train routine. Second, replace
the batteries in the remote control for the TV or VCR etc. If successful training cannot
be accomplished you may have a commercial transmitter that is not compatible with
the RELAX 3. To stop training, put the switch back to USE.
If the RELAX 3 detects an error when analyzing the received infrared signal and
is unable to “learn” the code, it will emit three short beeps and turn off its LED’s.
Try the train routine again.
** When training the RELAX 3, it may take up to 5 seconds.
** Some of the new remotes send two signals. The first is a short burst followed by
a second signal. If your remote is not training, hold for a longer time in case your
remote is sending two signals.
Use Mode:
1. Plug your Tash switch into the jack marked S1 or S2 at the side of the display.
2. To start the scan, hit the switch. The unit will automatically scan the top group
of LED’s.
3. When the device you wish to use is lit, hit the switch again.
4. The unit will then automatically scan the bottom group of LED’s representing the
actual infrared transmissions that can be sent. The scan goes from top to bottom,
and its speed is adjustable.
5. When the light is at the function that you wish to transmit, hit the switch.
The code will be transmitted for as long as the switch is held closed - for
example, if the function is “volume up”, the volume will be turned up for as
long as you hold the switch down.
NOTE: If the location selected has not been previously trained, the RELAX 3 will emit
a continuous tone when you try to transmit.
