SS-CDR200/SS-R200/SS-R100
Release Notes
2
TASCAM SS-CDR200/SS-R200/SS-R100
•
If the unit was turned on while an Apple USB
keyboard was connected, that keyboard might not be
recognized. This has been fixed.
•
In response to an RS-232C PLAY command, for
example, the Home Screen display would change to
TRACK mode. This is been fixed.
•
Some USB keyboards could not be recognized. This has
been fixed.
V1.12 fixes
•
With MP3 data CDs, some songs would not be
recognized on rare occasions. This has been fixed.
•
24-bit mono WAV files would not play back correctly.
This has been fixed.
•
The precision of the search position has been improved
when skipping forward and backward with VBR MP3
files.
V1.11 fixes
Fixed an issue when in Flash load mode, and going into
REC-Ready, followed by STOP and then PLAY, the audio
input while in REC-Ready mode was mistakenly played
back.
Now when going from REC-Ready mode to STOP, Flash
load mode is exited.
V1.03 fixes
When paused (standby), after pressing the CENTER switch
of a connected TASCAM RC-3F remote control set to
MODE 2 or 3 to start playback, releasing the switch would
pause the unit again. This has been fixed.
V1.02 fixes
•
The stability of operations related to USB flash drives
has been improved.
•
When changing the device to USB,
MEDIA READING
would appear and the unit would freeze in some cases.
This has been fixed.
•
Even when the unit was set to REMOTE using an RS-
232C REMOTE/LOCAL SELECT (4Ch) command, the
STOP button continued to function. This has been fixed
so that the STOP button is also disabled.
•
If you used an RS-232C DIRECT TRACK SEARCH PRESET
(23h) command to designate a track that was not
on the media, the command was ignored without
returning an
ILLEGAL (F2h)
message. This has been
fixed.
Checking the firmware version
Confirm the firmware version of your SS-CDR200/SS-R200/
SS-R100 before updating its firmware.
1 When the unit’s power is off, press and hold the
STOP, PLAY and READY buttons and press the
POWER switch to turn the unit on.
NOTE
Continue to press the buttons even after the startup
screen appears until the following screen is shown.
2 On this screen, check the
m ver.
,
build.
and
f ver.
versions.
If the
m ver.
,
build.
and
f ver.
firmware
versions shown here are the same or newer than
the firmware versions that you plan to update to,
then there is no need to update the firmware.
