Tascam Sonicview 16, Справочное руководство

Страница: 37 / 188

4 – Mixer configuration and settings
BUS CONFIG page
1
Page selection buttons
Tap these buttons to switch the page shown.
2
MIX 1–22 MODULE NAME area
o
This shows the module names and user module names for
the MIX1-22 modules.
o
Tap these buttons to open the MODULE NAME Screen
where the user module name and set module color can be
changed. (See “MODULE NAME screen” on page 122.)
3
BUS MODE area
Tap these buttons to change the bus modes of MIX 1–22
modules.
Button Function
AUX
Set the MIX bus that corresponds to the
button to function as an AUX bus.
SEND level, on/off and PRE/POST settings
can be made from each module to AUX
mode buses. (PRE/POST is only for input
modules.)
GROUP
Set the MIX bus that corresponds to the
button to function as a GROUP bus.
Only on/off can be set for modules to
GROUP mode buses. They are always sent
POST FADER.
NOTE
i
When BUS is changed from GROUP to AUX, the setting color
of corresponding MIX 1–22 modules will change to orange.
i
When BUS is changed from AUX to GROUP, the setting color
of corresponding MIX 1–22 modules will change to purple.
4
AUX bus counts
This shows the number of modules set to AUX in the BUS
MODE area.
o
“ST” shows the number of AUX mode module pairs that
have the stereo link setting on.
o
“MONO” shows the number of AUX mode modules that
have the stereo link setting off.
5
GROUP bus counts
This shows the number of modules set to GROUP in the BUS
MODE area.
o
“ST” shows the number of GROUP mode module pairs that
have the stereo link setting on.
o
“MONO” shows the number of GROUP mode modules that
have the stereo link setting off.
6
STEREO LINK button area
o
These show the stereo link settings states of the MIX1-22
modules.
o
Tap these buttons to turn the stereo link setting on/off for
the MIX 1–22 modules.
When the stereo link is on, the button will appear
highlighted.
7
PAN LINK button area
These buttons appear when MIX 1–22 module stereo link
settings are on and the BUS mode is AUX.
When the PAN LINK setting is on, the AUX bus pan/balance
(SEND PAN) setting is linked to the MAIN L/R bus pan/balance
setting.
8
Scroll knob and scrollbar
Drag the scrollbar left and right to show MIX1-22 modules
that are not shown on the screen. The screen can also be
scrolled by turning LCD knob 8.
NOTE
The screen can also be scrolled by swiping left and right
between the MIX1-22 module NAME area (
2
) and the PAN
LINK button area (
7
).
TASCAM Sonicview 16/Sonicview 24
37