Tascam MZ-223, Руководство пользователя

Страница: 10 / 92

10
TASCAM MZ-223
;
Cord holder
Attach the power cord of the included AC adapter
(TASCAM PS-M1524) here to prevent accidental
disconnection. (See “Connecting other equip-
ment” on page 10.)
z
DC IN 15V connector
Connect the DC plug of the included AC adapter
(TASCAM PS-M1524) here.
x
MONITOR OUT jacks
These RCA pin jacks are analog monitoring out-
puts.
c
MAIN OUTPUTS 1–3 (BALANCED) jacks
These analog outputs are XLR jacks. (1: GND, 2:
HOT, 3: COLD)
Use the ATTENUATOR (
h
) switches to change the
output levels.
v
MAIN OUTPUTS 1–3 (UNBALANCED) jacks
These RCA pin jacks are analog outputs.
Use the
ATTENUATOR
(
h
) switches to change the
output levels.
b
LINE A/B input jacks
These RCA pin jacks are analog line outputs.
Record players can be connected to the
LINE A
input jacks of channels 1–2. When connecting
a record player to these jacks, also connect its
grounding wire to the
|
(GND) jack (
k
), and set
the LINE/PHONO input selection switch (
l
) to
PHONO
.
Preparation
Connecting the power
Use the included AC adapter (PS-M1524) to connect a
power supply to the unit as shown below.
Power outlet
DC plug
TASCAM
PS-M1524 (included)
CAUTION
Always use the AC adapter (PS-M1524) that was
shipped with the unit. Using a different AC adapt-
er could cause malfunction, overheating, fire or
other problems.
NOTE
The AC adapter for the unit includes two types of
adapter cords. Attach the type of AC adapter cord
that matches the power outlet that you are using.
Attaching the cord
In order to prevent the cord from becoming discon-
nected during use, attach it to the cord holder (
;
)
when connecting it to the unit.
1.
Remove the cord holder (
;
) screw.
2.
Place the cord in the cord holder (
;
).
3.
Tighten the cord holder (
;
) screw.
Connecting other equipment
This is an example of MZ-223 connections.
Precautions before making connections
0
Carefully read the operation manuals of the de-
vices to be connected and then connect them
correctly.
0
Before making connections, turn this unit and all
equipment to be connected off (standby).
0
Install all connected devices, including this unit, so
that they are powered from the same line. When
using a power strip or similar device, be sure to
use one that has high current capacity (thick ca-
ble) in order to minimize fluctuations in power
voltage.
0
When connecting audio devices, minimize the
channel 1-5 GAIN knobs (
j
) and faders (
8
), and
the OUTPUT VOL (
q
) and PHONES VOLUME (
a
)
knobs. Failure to do so could cause sudden loud
noises from monitoring equipment, and this could
damage the equipment or harm hearing.