Tascam MM-2D-E, Руководство пользователя

Страница: 8 / 92

8
TASCAM MM-2D-E / MM-2D-X
Names of parts
Front panel
1
STATUS indicator
The
STATUS
indicator blinks blue under the following
conditions.
o
When no LAN cable is connected
o
When the Dante module is not operating properly
2
SAMPLE RATE indicator
The lit/unlit state of the three SAMPLE RATE indicators
(44.1k, 48k and ×2) show the sampling frequency status
of the unit.
44.1 kHz 48 kHz x2
44.1 kHz Lit Unlit Unlit
48 kHz Unlit Lit Unlit
88.2 kHz Lit Unlit Lit
96 kHz Unlit Lit Lit
3
OL indicators
These light when analog input signals overload.
4
IN SIG indicators
These light when sound is being input through the an-
alog inputs.
Input is judged to have occurred when the signal level
exceeds −60 dBFS.
5
OUT SIG indicators
These light when sound is being output through the an-
alog outputs.
Output is judged to have occurred when the signal level
exceeds −60 dBFS.
Rear panel
MM-2D-E
MM-2D-X
6
Analog input connectors
MM-2D-E
These are balanced Euroblock analog input connec-
tors. (HOT, COLD, GND from the left)
MM-2D-X
These are balanced XLR analog input jacks. (1: GND,
2: HOT, 3: COLD)
7
Analog output connectors
MM-2D-E
These are balanced Euroblock analog output connec-
tors.
(HOT, COLD, GND from the left)
MM-2D-X
These are balanced XLR analog output jacks.
(1: GND, 2: HOT, 3: COLD)
8
DC IN/DC OUT connectors
The DC-IN connector is above, and the
DC-OUT
connec-
tor is below. (Left is 12V, and right is GND.)
These connectors are specifically for power daisy-chain-
ing.
ATTENTION
Disconnect the AC adapter before connecting the
DC IN
and
DC OUT
connectors.
NOTE
i
Power daisy-chaining can be enabled by connecting the
DC OUT
and
DC IN
connectors. Power daisy-chaining of
up to two units is possible
i When powering by PoE, the first unit in the powerdai-
sy-chain will not be powered. In this case, use a dedicat-
ed PS-P1220E AC adapter (sold separately) to power the
first unit in the daisy chain.