Tascam FW-1082, Руководство по установке

Страница: 4 / 6

Pan & EQ
When the EQ/PAN LED is illuminated:
· The lowest of the four encoders shown at
right will control the Pan parameter of the
SELected channel in Sonar.
· The encoders labeled as GAIN,
FREQuency and Q will control those
parameters of the EQ band selected by the
illuminated buttons on the SELected
channel in Sonar. Bands 1­4 of Sonar’s
Channel EQ is supported.
· The first time an EQ Band key is pressed,
it selects the appropriate lower band,
pressing the same button again selects a
higher band. In this way, up to eight
bands can be controlled. (
Note: The
Sonar Channel Strip EQ does not support
external control of more than four bands
.)
· Holding SHIFT while pressing an EQ
band key will enable/disable that EQ
band.
· Holding the SET key while pressing an
EQ band key will toggle through the
available EQ curve types.
Sonar can come with up to three types of EQ,
depending on the version you have. The FW­1802 can be set to control any of the three:
· Hold the EQ/PAN key while pressing one of the top three EQ band buttons to
select an EQ:
o
EQ HI = Channel Strip Sonitus
o
EQ HI MID = Plug­in Sonitus
o
EQ LO MID = Plug­in FX EQ
Aux
When AUX 1­4 or AUX 5­8 is illuminated:
· The four encoders control the level of Aux Sends 1 – 4 or Aux Sends 5 – 8 of the
SELected channel in Sonar.
· Holding SHIFT while turning and encoder will adjust that Aux Send Pan.
· The four keys toggle Aux Send 1 – 4 enable/disable or Aux Send 1 – 5
enable/disable of the SELected channel in Sonar.
· Holding SHIFT while pressing one of the four keys toggles the Pre/Ppost state for
that Aux Send of the SELected channel in Sonar.