TASCAM DR-05
75
3 Press the MARK button at the end point of
the section that you want to play repeatedly.
This position is set as OUT (end) point, and
loop playback of the section between the IN
and OUT points starts. Then, appears at
the corresponding point under the playback
indicator bar.
During loop playback the
indicator also
appears.
Press the PB CONT button to return to the
Home Screen while maintaining the I/O and
loop settings effective. Even after returning to
the Home Screen, the
icon continue to be
shown, along with the and marks shown
at the points corresponding to the IN and OUT
points under the playback indicator bar.
NOTE
• The pop-up message of “I/O Too Short” appears if the
section between the IN and OUT points is too short. Set
them again. The section should be 1 second or longer.
• Press the
MARK
button again to clear the IN and OUT
points.
• To stop loop playback, press the
MENU
button when
the Playback Control screen is open. Press the
MENU
button again to start loop playback between the set IN
and OUT points.
• You cannot set the IN and OUT points in different files.
• The previous IN and OUT point settings are lost when you
set the IN point on a different file.
• Accurate assignment of IN and OUT points is not always
possible for variable bit rate (VBR) MP3 files.
6–Playback
