Tascam Celesonic us-20x20, Справочное руководство

Страница: 10 / 44

10
TASCAM US-20x20
4 – Preparation
Attaching the rack mount angles
Before mounting this unit in a rack, you must remove the frame
pieces and install the included rack mount angles. Follow these
procedures to attach the rack mount angles. (Prepare a Phillips
screwdriver in advance.)
1. Use the hex key included with this product to remove the
four screws from each side frame as shown in the illustration
below.
2. Remove the frames from both ends of the unit.
3. Use the Phillips screwdriver that you prepared to attach the
included rack mount angles using the included rack mount
angle installation screws.
NOTE
Reverse these procedures to reinstall the frames that were
originally attached to the unit.
Connecting the power
Use the included AC adapter (GPE248-120200-Z) to connect a
power supply to the unit as shown below.
GPE248-120200-Z (included)
Power outlet
DC plug
In order to prevent the cord from becoming disconnected
during use, wrap it around the cord holder when connecting it.
CAUTION
Always use the AC adapter (GPE248-120200-Z) that was
shipped with the unit. Using a different AC adapter could
cause malfunction, overheating, fire or other problems.
NOTE
The AC adapter for the unit includes two types of outlet
plugs. Attach the type of plug that matches the power outlet
that you are using. (See “Changing the outlet plug” on page
10.)
Changing the outlet plug
$ %
2
1
5
3
4
1 Move the latch on the AC adapter in the direction of
the arrow.
2
Pull off the outlet plug.
3
Replace it with the other outlet plug (A or B).
4
Move the latch on the AC adapter in the direction of
the arrow again.
5 Attach the outlet plug to the AC adapter.
After changing the outlet plug, confirm that it is not loose
or crooked and that everything is normal before plugging it
into an outlet
CAUTION
Do not use the adapter if there is anything abnormal about
the plug after changing it. Use when the plug is abnormal
could cause fire or electric shock. Contact the retailer where
you purchased the unit or a TEAC service center (on the back
cover) to request repair.