TASCAM 302MKII
9
Unless you use multiple 302MkII units connected in
series, set the OFF/SLV/MSTR switch to the left OFF
position all the time.
1.
Check to see that the source is connected to the
DECK 1 INPUT connectors if you intend to record
on deck 1 only or on deck 1 and deck 2 simul-
taneously. Use the DECK 2 INPUT connectors if
you intend to record on deck 2 only.
2.
Press
POWER
to turn on the unit.
3.
Press either or both
EJECT
buttons to open the
cassette compartments, insert cassettes, and close
the compartments.
4.
Press either or both
RESET
buttons so you can use
the RTZ (return-to-zero) function to locate the
record start point.
5.
Make the following switch settings :
REV MODE
switch to
Ä
if you intend to record
on one side of the tape(s) only or
ä
to record on
both sides continuously ;
INPUT/OUTPUT
switch to
SEPARATE
;
DOLBY NR
switch to the desired position.
6.
If you intend to record on both deck 1 and deck 2
simultaneously, press the
DUAL REC
button. Its
LED will turn on and both decks will go into
Record Ready mode.
If you are using only one of the two decks, put it
i n t o R e c o r d R e a d y m o d e b y h o l d i n g d ow n
RECORD
and pressing
PAUSE
.
7.
Start the external source and adjust the
INPUT
control(s) so that the meter reading is around 0 dB.
Use the
REC BAL
control(s) to balance the left and
right input levels.
8.
To start recording, press
PLAY
on the deck in use. If
DUAL REC is activated, you can press PLAY on
either deck to start recording on both decks.
“
To stop recording, press
STOP
. If DUAL REC is
activated, you can press STOP on either deck to
stop both tapes. The DUAL REC LED will then
turn off.
“
To audition the recording just completed, press
RTZ
, then press
PLAY
for the deck whose LED is
blinking.
Suggestion :
You can record a 4-second silence by
holding down
RECORD
and pressing
STOP
(or by
pressing the optional remote
REC MUTE
button) after
p r o g r a m m a t e r i a l a s b e e n r e c o r d e d . T h e C P S
(Computer-controlled Program Search) function
(discussed below) identifies specific programs by
counting a blank space of 4 seconds or more between
programs.
Recording on Either Deck, or Both at the Same Time
Using a Single Unit
