Tarmo XTP120, Инструкция по эксплуатации, Страница: 66 / 80

66
Drift Cutters (if so equipped)
Drift Cutters break up snow drifts that are taller
than the auger housing and direct the snow into
the auger. Store the drift cutters on the auger
housing when not in use. Reposition the drift
cutters so they face forward as shown. Wing nuts
should be fastened on the outside of the auger
housing.
Fuel Shutoff Valve
Always operate the snow blower with the fuel shut-
off valve in the OPEN position. Close the valve
when you do not use the machine.
Throttle Lever
Move the throttle lever to the right to increase the
engine speed; move it to the left to decrease the
engine speed. Move the throttle lever to the Stop
position to stop the engine.
Choke
Engage choke by rotating lever to FULL position
whenever you are starting a cold engine. As
engine warms up, gradually rotate the choke to the
OFF position.
Do not use choke to start a warm engine.
Never use choke to stop engine.
Primer
Press the primer to additional fuel from the
carburetor to the cylinder for improved cold
weather starting.
Recoil Starter
The recoil starter is on the back side of the engine.
Pull the recoil starter handle to start the engine.
Safety Ignition Switch (if so equipped)
Insert the safety ignition key for engine to start and
run. To stop the engine, remove the key.
ON/OFF switch (if so equipped)
Used for stopping the engine. Move switch to OFF
position to stop engine. Place switch in ON
position for engine to start and run.
Ignition Switch (12V start) (if so equipped)
The ignition switch is operated by a removable key
which has 3 positions of STOP, RUN and START.
Electric Starter & Start Button (if so equipped)
The electric starter will start a properly choked and
cranked engine when the key is turned (12V DC)
or start button (120V or 230V AC) is pushed.
To start the machine, connect the electric starter
to an electric power source with an approved
extension cord and press the start button.