Target DT11H, Инструкция по эксплуатации и перечень запасных частей

Страница: 26 / 52

26
Assembly (Not Shown). Remove
these Capscrews, Lockwashers, and
Washers from the machine. This
hardware was used only to plug holes
in the gearbox.
6) Using the two (2) M8 Capscrews,
Lockwashers, and Washers supplied
in the kit, mount the Nozzle Bracket
Assembly with the hose barb fitting
toward the rear of the machine.
7) Take the free end of the Water Tank
Hose and slide a Hose Clamp [QQ 4]
loosely over the hose. Route the hose
through the side of the machine [See
FIG. 1 and the opened Dust Port
Cover [FIG. 31]. Attach the hose to
the Hose Barb fitting on the Nozzle
Bracket Assembly.
8) Slide the Hose Clamp down the hose
until it is on the Hose Barb fitting at the
Nozzle Bracket. Tighten the M6
Capscrew, and Lockwasher that hold
the Hose Clamp [QQ 4].
9) Install two (2) more Hose Clamps [QQ
4] along the frame [See FIG. 1].
10) Make sure the Water Valve (QQ 1) is
closed before adding any water to the
water tank.
WARNING: DO NOT lift the machine into the
air if the Water Tank is filled with water. This
added weight will cause the balance point to
be shifted so that the machine will not lift in a
horizontal position.
11. Repairs
We carry out all repairs in the shortest possible time
and at the most economical prices. See front cover for
our address and telephone numbers.
12. Spare Parts
For a quick supply of spare parts it is essential to quote
the data shown on the Serial Number Plate [VV] [See
FIG. 13] fixed to the machine. Make note of this
information & the purchase date below, and on the
front cover of this document for quick reference:
Model:
_____________
Serial No:
_____________
Date:
_____________