5
SENSORS TO PAGER RECEIVER
Configuring your Sensor to your Receiver
1. Press and release the
POWER
button.
2. With the keypad unlocked, press the
MODE
and
UP
key at the same time and then release. You will see
‘Code Learning’ on the display.
3. Use the
DOWN
button to select the zone that you
would like to program (1-16). If the zone is already
occupied, “Use” will show in the display.
4. Use the
UP
button to select the tune that you want to
play when the zone is activated.
5. Once you have found your preferred tune, activate
your Alert Sensor:
•
PIR
: wave your hand in front of the Sensor which
will configure the two devices. A small beep will
sound to confirm the configuration.
•
Solar Beams:
Sensor A - press and release the
POWER
button. This will send a signal to your
Receiver for connection. A short beep will sound
on the Receiver to confirm the configuration.
•
Probe
: pass a metal object (such as a hammer or
key) by the probe, or manually move the probe a
few inches. The receiver emits a short beep.
•
Directional Probe:
•
Vehicles Entering:
Activate the wireless probe
transmitter by pressing the “A” button on the
transmitter board. You should hear a short beep
from the receiver.
•
Vehicles Leaving:
Activate the wireless probe
transmitter by pressing the “B” button on the
transmitter board. You should hear a short beep
from the receiver.
6. The display will now show “Use” to indicate that the
Sensor has been programmed to that zone.
SET UP
.
