16
Auxiliary Output 3 - black/yellow wire
(200mA positive) - continued
2) Auxiliary Output 3 - HOLD - +12V positive signal.
In this setting the Auxiliary 3 output is activated after pressing the control's Off button for more
than 3 seconds, keeping it pressed, after other 2 seconds it also activates Auxiliary 2. Releasing
the Off button, for the Auxiliary 2 signal and the Auxiliary output 3 will remain on (HOLD).
Auxiliary output 3 will only be turned off when pressing the control's Off button again.
With the alarm and ignition off, holding the remote control Off button for more than 3 seconds
activates the outputs, auxiliary 2 (negative signal) and auxiliary 3 (positive signal). When
releasing the button, it stops the signals.
Output activated WITH auxiliary output 2.
1) Auxiliary Output 3 - PULSE - Positive 12V.
Output activated WITH auxiliary output 2.
Example of Operation:
To start the vehicle, connect the black/yellow wire to the relay for connecting the key post and
the brown wire to the starter motor relay.
- Holding the control off button pressed, first activates the black/yellow wire, turning on the
ignition, then activating the brown wire, activating the starter motor, release the off button
after the engine starts running.
As the black/yellow wire (Auxiliary output 3) is in hold mode, the ignition will remain on
keeping the engine running.
- To turn off the engine (black/yellow wire), press the off button on the control again.
WARNING: Risk of accidents in case of incorrect installation.
It is necessary to use sensors and relays so that it is only possible to activate the vehicle's
starter motor with the gearshift in the NEUTRAL position.
3) Headlight control
4) Horn Output
5) Dedicated Siren Output
Automatically turns t he headlight on 5 seconds after turning on the ignition and turns off the
headlight when turning off the ignition and opening the door. Relay use required.
With this setting, a wired Dedicated Siren can be installed, with or without wireless. Only use
dedicated siren, 12 volt siren can not be installed.
With this setting the vehicle's horn or another one can be used.The horn will sound when
switching on, off or when the alarm goes off. If you do not want the on/off tone, cancel by
programming.The use of auxiliary relay is required.
Activate Auxiliary outputs 2 and 3
- Press and hold the OFF key on the control with the
ignition off and the alarm off.
+ than 3
seconds
