11
Note:
In case of
compression drivers
and tweeters you must install a passive filter in the positive terminal of the same
ones (Consult transducer’s manufacturer manual).
Connection example in the output: Subwoofer.
If you choose to use this input, you won’t need to connect
the RCA’S cable and remote signal.
Wire Input:
*Illustrative images
Remote Cable 18 AWG
4mm² (11 A
WG)
2,5mm² (13 A
WG)
2,5mm² (13 A
WG)
RCA Cable
Taramps
12V
GND
4mm² (11 A
WG)
CUIDADO
T h e e n t i r e
a l u m i n u m
surface of the amplifier serves as a heat
sink. The usually working temperature is
65°C. So, avoid contact with this surface
when the amplifier is in use.
Head Unit
CUIDADO
This equipment is not
suitable for use in places where children
may be present.
Remote cable ___________________
______________________________________ 18 AWG
Positive / negative power supply cable ___________________
__________________11 AWG
Output cables wire gauge_______________________________
________________13 AWG
Protection fuse or circuit breaker
_____________________________________________20A
Calculated considering a maximum length of 4m. Distance greater than this, you will need to
increase the cable gauges.
Installation
Recommended wire gauge & fuse
CAUTION: All connections to power supply, input and output connectors must
be carried out only with amplifier off.
CAUTION
It is compulsory to install a protection fuses or circuit breakers as close as possible from batteries.
Check polarity and never reverse power supply cables due to the risk of damage to the amplifier.
Using wire gauges below the recommendation will result in power loss and
overheating of wiring.
CAUTION
