14
- The microphone signal has a low amplitude, so improper use can cause unwanted noise.
- Do not wrap the microphone cables.
9 -AUX1 / OPTICAL or AUX 2 KEY:
Button pressed: Selects AUX1 and Optical inputs.
Button not pressed: Selects the AUX 2 input. (Inputs on the rear panel).
12 - MIC:
P10 input for microphone.
10 - ATT:
LED audio attenuation indicator. When identifying an audio signal from the
microphone input or emitting the ding-dong signal (GONGO), the equipment attenuates the
output signal, allowing higher evidence of the microphone. After 2 seconds without using the
microphone, it returns to the state without attenuation.
It is possible to enable or disable this function. With the device in standby mode, press and
hold the gong key for 5 seconds. The ATT LED will flash 3x with the function enabled or 1x with
the function disabled.
11 - VOL MASTER:
Controls the global volume level and must be used to adjust the output
power desirable.
Microphone Recommendations:
- Use quality cables and connectors.
- Do not pass the microphone in front of the loudspeakers. This causes feedback.
14 - GONGO:
GONGO activation key.
15 - EQUALIZATION:
Ways equalization adjustment
LOW: Bass frequencies
13 - VOL MIC:
Adjusting the volume of the microphone and the GONGO (ding-dong). If you
do not use the microphone and GONGO, it is recommended to keep the volume to a
minimum.
MID: Middle frequencies
HIGH: High frequencies.
16 - VOL CH L / VOL CH R:
Adjust each channel level (L ou R).
17 - LED ON:
Indicates that the product is turned on.
The product has 3 GONGO options. To select another option with the device on, press and
hold the “GONGO” key. The 3 gong patterns will be emitted in sequence (do not release the
key). To select an option, release the “GONGO” key after hearing the desired option.
18 - TECLA ON/OFF:
Main ON/OFF switch.
Front Panel
(sequence)
Knowing your equipment
